If the scanner is not working properly, please follow the steps below to reset it to the factory defaults and then reprogram to work within Design Manager. Test your scanner by scanning a DM Inventory label inside DM POS system or with Notepad open.Then Scan each of the following barcodes below to reprogram the scanner:.Scan the Return to factory Defaults ? Set Defaults barcode.If you have this paper, please scan the following barcodes (you can also print this article out and scan the below barcodes): Your scanner was shipped with a Guide that is blue and white. Motorola LS2208 and Motorola LI4278 - Cordless: Review the section for the scanner you have purchased below for more help. You do NOT need to continue with this article unless you are experiencing issues with the device and have been instructed to do so.ĭesign Manager offers three POS scanners for purchase to use with the POS system to scan items purchased by a customer. IMPORTANT NOTE: If you have purchased your POS scanner from Design Manager, your scanner has been shipped already programmed for you. When there’s an object passes the sensitive area (the sensitive area depends on the size of the object, normally is 5-30cm), the scanner will scan automatically. Programming POS Scanners and Resetting to Factory Defaults 1.If it is an automatic barcode scanner, it has already been well set with the auto scanning function.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |